-
12%
Piles reduction
-
20º
Slope tolerance N-S
-
Compatible
with cleaning robots
-
29.6%
Torsion resistant increase
The best tracker solution for desert scenario
The best tracker solution for desert scenario
✓ Newly optimized Spherical Bearing with a surface and design that stops sand accumulations.
✓ Vanguard 1P damper has been optimized to avoid the introduction of sand and dust into the chamber.
✓ All motors, CTU and NCU devices, are water and dust proved, having successfully passed grade IP66, IEC 60529.
✓ The TCU is positioned high off the ground to prevent the intrusion of sand and dust.
Trina Clamp reduces 65% installation time
√ TrinaTracker proprietary technology globally patented
√ Quick and easy to use with the 1P configuration
√ Reduces module installation time
√ Reduces assembly cost
Incredible fast assembly and wind tolerance
√ Single-row tracker
√ Compatible with bifacial and ultra-high power modules + 670W
√ Dual-damper system achieves a 20% improvement in the tracking resistance to wind gusts in all directions.
√ Innovative modular design enables 17.5% installation time saving
√ Rounded edge torque tube design 130X130 for long spans and high loads:
• Torsion resistance Increased by 29.6%
• Bending resistance Increased by 12.4%
√ 90 modules per tracker
√ Slope tolerance up to 20º N-S
√ Comprehensive wind tunnel test performed by CPP
Global Patented Spherical Bearings
• Up to 30% angle adjustability.
• Alleviate the damage caused by uneven foundation settlement during the life cycle of the tracker system
• Release the extra stress caused by the deformation of the tracker system and reduce the load and failure rate of each component
Trina Clamp reduces 65% installation time
✔ TrinaTracker proprietary technology globally patented
✔ Quick and easy to use with the 1P configuration
✔ Reduces module installation time
✔ Reduces assembly cost
Would you like to know more about TrinaTracker?
Contact us and boost your energy beyond the horizon
CONTACT US